Seal Krete Logo

Seal and Enhance Pavers

Supply Checklist

  • SEAL-KRETE Oil Stain Remover
  • SEAL-KRETE Wet-Look Penetrating Surface Sealer
  • SEAL-KRETE Clear-Grip (optional)3/8 nap paint roller or pump sprayer
  • Safety goggles, rubber gloves, protective clothing
  • Stiff-bristled broom
  • Pump sprayer or watering can
  • Garden Hose with Spray Attachment

Prep & Prime

Proper surface preparation is critical to the success of all SEAL-KRETE coatings. The surface should be clean, dry, sound and free of dirt, dust, oil, wax and grease. You may need an oil stain remover such as SEAL-KRETE® Oil Stain Remover to lift stubborn oil stains. Pressure-washing is recommended.

Do not apply to painted or stained surfaces. Do not apply over solvent or oil-based stains. Make sure all cure and seal compounds have been removed. Repair all cracks and surface breaks. Cover windows, doors, etc., prior to application. Use caution when applying on windy days. Remove any overspray immediately with water. New concrete must cure for a minimum of 30 days.

Apply

SEAL-KRETE Wet-Look Penetrating Surface Sealer  is ready to use; do not dilute. Do not apply if rain is expected within 24 hours. Temperatures should not fall below 50°F (10°C) within 24 hours of application. Apply to porous, bare, uncoated concrete and masonry surfaces only. Etch smooth-finished concrete (such as patios or porches) with a concrete etching solution like SEALKRETE. Clean-N-Etch. Apply until saturated using a brush, roller (3/8” nap), or low-pressure garden sprayer. Apply first coat, backrolling any puddles, and let dry 4 hours. Apply a second coat to maximize protection. Backroll to remove any puddles. On vertical surfaces, apply from the bottom up and saturate well.

To improve slip resistance on horizontal surfaces, add SEAL-KRETE Clear Grip.

Clear-Grip Non-Slip Grit Additive

Coverage: 150-400 sq. ft. per gallon, depending on surface porosity.

SUBSCRIBE TO OUR NEWSLETTER